Differential Housing Cover: Removal

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Aluminum cover shown in illustration, steel cover similar.

If equipped with aluminum cover, remove the panhard rod. Refer to REAR SUSPENSION .
If equipped.
If equipped.
- To install, tighten the bolt to 10 Nm (89 lb-ft).
If equipped.
NOTE: The differential housing cover must be installed within 15 minutes of application of the silicone sealant, or new sealant must be applied. If possible, allow one hour before filling the axle housing with axle lubricant to make sure the silicone sealant has cured.
- To install, tighten steel cover bolts to 46 Nm (34 lb-ft).
- To install, tighten aluminum cover bolts to 32 Nm (24 lb-ft).