Symptom Chart
WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
Diagnostics in this information assume a certain skill level and knowledge of Ford-specific diagnostic practices. Refer to DIAGNOSTIC METHODS
for information about these practices.
SYMPTOM CHART
| Condition |
Possible Sources |
Action |
- No communication with the VDM
|
- Fuse(s)
- Wiring, terminals or connectors
- VDM
|
|
- Damper icon flashes and FAULT is displayed below the icon
|
- Wiring, terminals or connectors
- Strut or shock solenoid
- VDM
|
- The message indicates a hardware fault exists in the vehicle dynamic suspension system. RETRIEVE and DIAGNOSE all VDM DTCs.
|
- Message center displays, CHANGE NOT AVAILABLE when the ride control switch is pressed
|
- Wiring, terminals or connectors
- IPC
- ABS module
- PCM
|
- The VDM has lost communication with 1 or more modules or has received invalid information from 1 or more modules. RETRIEVE and DIAGNOSE all VDM DTCs.
|
- Cannot change suspension modes using the ride control switch
|
- Refer to the Diagnostic Routine
|
|