Compass Zone Adjustment
WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
This procedure is only applicable to vehicles without navigation. For vehicles with navigation, there is no compass zone adjustment.
- Refer to the compass calibration zone map in illustration to select the correct compass zone setting for the geographic location of the vehicle.
- With the ignition in the ON position, press and hold the Front Controls Interface Module (FCIM) 7 and 9 buttons (for approximately 5 seconds) until the compass display shows the current zone setting (ZONE XX). Release the 7 and 9 buttons.
-
NOTE: After the FCIM 7 and 9 buttons have been released for approximately 5 seconds, the compass display exits the zone setting mode.
Before the zone setting mode turns off (within 5 seconds), momentarily press and release the 7 and 9 buttons to increase the zone increment by one. Set the zone display number to match the vehicle geographical location on the compass calibration zone map.
-
NOTE: After the FCIM 7 and 9 buttons have been released for approximately 5 seconds, the compass display exits the zone setting mode.
Release the 7 and 9 buttons and wait for 5 seconds to exit the zone setting mode.