Removal and Installation

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Do not remove the ignition lock cylinder and the ignition switch at the same time or damage to the column may result.

Depower the Supplemental Restraint System (SRS). For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM .
Remove the steering column shroud. For additional information, refer to STEERING COLUMN .
Disconnect the ignition switch electrical connector.
Release the 2 locking tabs and remove the ignition switch.

Fig 1: Locating Ignition Switch Electrical Connector
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.
Repower the SRS. For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM .