LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Limited, 3.5 8, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 140 (Seat System - Seats) >> Removal And Installation >> Seat Track - Manual >> Removal

Seat Track - Manual: Removal

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: To prevent system failure, it is necessary to carry out the OCCUPANT CLASSIFICATION SENSOR (OCS)  system reset when a front passenger seat cushion is disassembled, a new trim cover is installed or an OCS system service kit is installed. A scan tool is used to carry out the OCS system reset.
NOTE: For parts identification and location, refer to SEAT - EXPLODED VIEW, FRONT .
NOTE: Note all wire harness routing for correct installation.
  1. Remove the seat. For additional information, refer to SEAT - FRONT .
  2. Remove the clip and recline handle.
    • Access the clip from between the cushion cover and side shield.
  3. If equipped, remove the manual height adjust handle.
    • Remove the cover.
    • Remove the 2 screws and handle.
  4. NOTE: Do not reinstall the cushion side shield or side shield retainers after removal. These are one-time-use items that become damaged during removal and may not remain attached if reinstalled. Install a new side shield during seat assembly.

    Remove and discard the cushion side shield.

    • Remove the screw at the rear of the cushion side shield.
    • Separate the side shield retainers from the seat.
    • Remove the side shield and any retainers that remained attached to the seat.
  5. Disconnect the seat position sensor and detach the wire harness retainer.
    • If installing a new seat track, remove the bolt and seat position sensor.
  6. Separate the side air bag module electrical connector and wire harness from the seat track bracket.
    Fig 1: Locating Side Air Bag Module Electrical Connector And Wire Harness
    G06393165Courtesy of FORD MOTOR CO.
  7. Disconnect the safety belt buckle electrical connector and separate the wire harness from the seat track.
  8. Separate the seat wire harness and electrical connector from the seat track.
  9. Release all seat cushion cover fasteners from the cushion frame.
  10. Lift the cushion foam pad for access and remove the 4 nuts and seat track.
  11. If a new seat track is being installed, remove the bolt and safety belt buckle.
scientia non olet · About LEMON Manuals