Seat Backrest Heater Mat: Removal
WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Do not reinstall any heater mat or foam pad after removal. The adhesive will not adhere correctly to the foam pad, causing it to bunch up or shift out of place. A new heater mat and a new foam pad must be installed. Failure to follow these instructions can result in heated seat component damage and system failure.
NOTE:
For parts identification and location, refer to SEAT - EXPLODED VIEW, FRONT .
- Remove the seat backrest cover. For additional information, refer to SEAT BACKREST COVER - FRONT .
- Disconnect the backrest heater mat electrical connector.
- Note wire harness routing for correct installation.
- Remove and discard the backrest foam pad and heater mat.