LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Limited, 3.5 8, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 140 (Seat System - Seats) >> Removal And Installation >> Seat - Front >> Installation

Seat - Front: Installation

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the seat in the vehicle and connect the electrical connectors.
  2. Install and hand-tighten the 2 front bolts and 2 rear nuts.
    • For manual seat track, make sure both track rails are correctly aligned and locked in position before tightening the seat mounting fasteners.
  3. Tighten the seat mounting fasteners in the following sequence:
    1. Tighten the inboard front bolt to 48 Nm (35 lb-ft).
    2. Tighten the outboard front bolt to 48 Nm (35 lb-ft).
    3. Tighten the inboard rear nut to 48 Nm (35 lb-ft).
    4. Tighten the outboard rear nut to 48 Nm (35 lb-ft).
  4. Install the 2 rear nut covers.
  5. Repower the SRS. For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEPOWERING AND REPOWERING .
scientia non olet · About LEMON Manuals