Lumbar Control Switch: Installation
WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
- Install a new cushion side shield.
- If equipped, install the seat control switch:
- Install the switch into the side shield.
- Install the knob.
- Connect the electrical connector.
- Install the power lumbar switch.
- Install the switch into the side shield.
- Connect the electrical connector.
- Make sure all the side shield retainers are attached to the side shield.
- Install the side shield and screw to the seat.
- If equipped, install the seat control switch:
- Install the recline handle and clip.