Seat Cushion - Front: Disassembly

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: For parts identification and location, refer to SEAT - EXPLODED VIEW, FRONT .

NOTE: Note all wire harness routing for correct installation.

Passenger seat

Remove the OCS. For additional information, refer to OCCUPANT CLASSIFICATION SENSOR B.
Driver seat
Remove the seat cushion cover. For additional information, refer to SEAT CUSHION COVER - FRONT .
If equipped, detach the heated seat wire harness from the cushion frame and disconnect the heated seat system electrical connector(s).
Remove the cushion foam pad.
All seats
Remove the seat track. For additional information, refer to SEAT TRACK - MANUAL or SEAT TRACK - POWER .
Release all remaining wire harness pin-type retainer(s) and remove from the cushion frame.