Seat Cushion - Front: Assembly
WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Do not reinstall any heater mat or foam pad after removal. The adhesive will not adhere correctly to the foam pad, causing it to bunch up or shift out of place. A new heater mat and a new foam pad must be installed. Failure to follow these instructions can result in heated seat component damage and system failure.
All seats
- Install the seat wire harness and retainers to the cushion frame as noted during removal.
- Install the seat track. For additional information, refer to SEAT TRACK - MANUAL or SEAT TRACK - POWER .
Passenger seat
NOTE: Do not install a new heater mat on a front passenger seat cushion. Install a new Occupant Classification System (OCS) system service kit. Failure to follow this instruction can cause incorrect OCS operation. Refer to SUPPLEMENTAL RESTRAINT SYSTEM for the Occupant Classification Sensor Removal and Installation procedure. - Install the OCS. For additional information, refer to OCCUPANT CLASSIFICATION SENSOR
.
Driver seat
- Install the seat cushion foam pad.
- If equipped, attach the heated seat system wire harness to the cushion frame and connect the electrical connector(s).
- Install the seat cushion cover. For additional information, refer to SEAT CUSHION COVER - FRONT .