Crossmember - Transmission, 5.8L (4V): Installation

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

Position the crossmember to the vehicle with the same orientation as when removed.
Loosely install the transmission crossmember bolts.

Fig 1: Locating Transmission Crossmember Bolts
Courtesy of FORD MOTOR CO.
Loosely install the transmission support insulator bolt.

Fig 2: Locating Transmission Support Insulator Bolt
Courtesy of FORD MOTOR CO.
NOTE: The transmission support insulator must be neutralized.

Slide the transmission crossmember forward, rearward and side-to-side until the gaps between the transmission support insulator and the transmission crossmember are equal.
With the transmission support insulator neutralized, tighten the transmission crossmember bolts.
- Tighten to 63 Nm (46 lb-ft).
  
  Fig 3: Locating Transmission Crossmember-To-Floor Pan Screws
  Courtesy of FORD MOTOR CO.
With the transmission support insulator neutralized, tighten the transmission support insulator bolt.
- Tighten to 70 Nm (52 lb-ft).
  
  Fig 4: Locating Transmission Support Insulator Bolt
  Courtesy of FORD MOTOR CO.