Crossmember - Transmission, 3.7L and 5.0L: Installation

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

With the same orientation as removed, position the transmission crossmember to the vehicle.
Loosely install the transmission support insulator nuts.

Fig 1: Locating Transmission Support Insulator Nuts
Courtesy of FORD MOTOR CO.
Loosely install the transmission crossmember bolts.

Fig 2: Locating Transmission Crossmember Bolts
Courtesy of FORD MOTOR CO.
NOTE: The transmission crossmember must be neutralized.

Slide the transmission crossmember forward, rearward and side-to-side until the gaps between the transmission support insulator and the transmission crossmember are equal.
With the transmission crossmember neutralized, tighten the transmission support insulator nuts.
- Tighten to 70 Nm (52 lb-ft).
  
  Fig 3: Locating Transmission Support Insulator Nuts
  Courtesy of FORD MOTOR CO.
With the transmission crossmember neutralized, tighten the transmission crossmember bolts.
- Tighten to 63 Nm (46 lb-ft).
  
  Fig 4: Locating Transmission Crossmember Bolts
  Courtesy of FORD MOTOR CO.
Remove the transmission jack.