LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Limited, 3.5 8, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 139 (Body System - Uni-Body, SUBFRAME & Mounting System) >> Removal And Installation >> Crossmember - Front >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. If equipped, remove the crossmember brace. For additional information, refer to CROSSMEMBER BRACE - EXPLODED VIEW .
  3. Release the brake line from the 2 clips on the front crossmember.
  4. Loosen the A/C line bracket nut and release the A/C line bracket from the front crossmember.
    • To install, tighten to 7 Nm (62 lb-in).
  5. Release the power steering line locator from the crossmember.
  6. Using a suitable tool, support the radiator.
  7. Remove the 4 front stabilizer bar bracket nuts.
    • To install, tighten to 70 Nm (52 lb-ft).
  8. NOTE: Two technicians are needed to carry out this step.

    Remove the 4 nuts and the front crossmember.

    • To install, tighten to 115 Nm (85 lb-ft).
  9. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals