Removal And Installation: Muffler: Installation

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

Position a new ball clamp on the muffler assembly.
NOTE: Lubricate the muffler assembly isolators with soapy water to ease in installation.

Slide the muffler assembly 2 hooks into the front isolator and then attach the rear isolator.
Tighten the new intermediate pipe-to-muffler inlet ball clamp.
- Tighten to 30 Nm (22 lb-ft).