Exhaust Intermediate Pipe: Installation

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

Position a new ball clamp on the muffler assembly.
Position the intermediate pipe in the vehicle.
NOTE: Similar catalytic converter or exhaust H-pipe shown in illustration.

NOTE: Make sure that the catalytic converter or exhaust H-pipe is inserted into the couplers correctly.

Slide the Torca® coupler over catalyst pipe or exhaust H-pipe and engage the coupler clip completely over the converter or H-pipe button.
- Tighten to 48 Nm (35 lb-ft).
  
  Fig 1: Locating Coupler Over Catalyst Pipe
  Courtesy of FORD MOTOR CO.
Tighten the new intermediate pipe-to-muffler inlet ball clamp.
- Tighten to 30 Nm (22 lb-ft).