Toe Adjustment - Front

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

Start the engine and center the steering wheel.
Turn the engine off and, using a suitable steering wheel holding device, lock the steering wheel in the straight ahead position.
Using alignment equipment and the manufacturer's instructions, measure the front toe.
Remove the clamps.

Fig 1: Locating Clamps
Courtesy of FORD MOTOR CO.
Loosen the tie-rod jam nuts.

Fig 2: Locating Tie-Rod Jam Nuts
Courtesy of FORD MOTOR CO.
NOTE: Do not allow the steering gear bellows to twist when the inner tie rod is rotated.

Rotate the inner tie rods until the toe reading is within specifications.

Fig 3: Locating Inner Tie Rods
Courtesy of FORD MOTOR CO.
NOTE: Do not allow the inner tie rods to rotate while tightening the tie-rod jam nuts.

Tighten the tie-rod jam nuts to 55 Nm (41 lb-ft).

Fig 4: Locating Tie-Rod Jam Nuts
Courtesy of FORD MOTOR CO.
Install the clamps.

Fig 5: Locating Clamps
Courtesy of FORD MOTOR CO.
Recheck the toe settings and adjust as necessary.