Bumper Rust Prevention - Front, Chrome: Material
WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
| Item | Specification |
|---|---|
| High Temperature Anti-Corrosion Coating PM-13-A |
- |
| Motorcraft® Custom Bright Metal Cleaner ZC-15 |
ESR-M5B194-B |
- If equipped remove the license plate bracket.
- If equipped, remove the foglamp assembly. For additional information, refer to EXTERIOR LIGHTING .
- If equipped, disconnect the fog lamp wiring harness retainers.
- Remove the front bumper. For additional information, refer to BUMPER - FRONT .
- Remove the 2 bolts and the front bumper bracket.
- Clean excessive dirt from an area of 2" (50 mm) around all 3 cutouts on the inside of the bumper.
-
NOTE: Use protective gloves when applying the Motorcraft Custom Bright Metal Cleaner.
Clean the red rust stains from the inside edges of the center vent and fog lamp openings with Motorcraft Custom Bright Metal Cleaner.
- Apply masking tape around the center vent and the fog lamp openings on the outside chrome part of the front bumper allowing for a 1 inch overhang into the openings.
-
NOTE: Use protective gloves when applying the anti-corrosion coating.
Using a foam brush, paint the edge of the center vent and the fog lamp openings and at least 1" (25 mm) around the inside of the front bumper with the Motorcraft Anti-Corrosion Coating.
- Remove the masking tape from around the center vent and the fog lamp openings.
- Install the 2 bolts and the front bumper bracket, tighten to 48 Nm (35 lb-ft).
- Install the front bumper. For additional information, refer to BUMPER - FRONT .
- If equipped, connect the fog lamp wiring harness retainers.
- If equipped, install the fog lamp assembly. For additional information, refer to EXTERIOR LIGHTING .
- If equipped, install the license plate bracket.