LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Limited, 3.5 8, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 113 (Sunroof - Roof Opening Panel) >> General Procedures >> Roof Opening Panel Alignment

Roof Opening Panel Alignment

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The roof opening panel motor must be initialized when repairs are carried out on any part of the roof opening panel, including: whenever the roof opening panel motor has been removed from the roof opening panel assembly, a new roof opening panel motor has been installed or when a new roof opening panel assembly has been installed. For additional information, refer to ROOF OPENING PANEL MOTOR INITIALIZATION .
  1. Position the roof opening panel in the CLOSED position.
  2. Loosen the 4 roof opening panel glass screws.
  3. NOTE: Make sure the roof opening panel is centered in the roof opening.

    Adjust the roof opening panel glass height to specification.

    Fig 1: Identifying Roof Opening Panel Glass Height
    G06173911Courtesy of FORD MOTOR CO.
  4. Maintain horizontal and vertical roof opening panel positions while adjusting and tighten the 4 roof opening panel glass screws to 4 Nm (35 lb-in).
  5. Initialize the roof opening panel motor. For additional information, refer to ROOF OPENING PANEL MOTOR INITIALIZATION .
scientia non olet · About LEMON Manuals