Removal and Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

Manually position the sliding glass to the full OPEN position.
Remove the upper rail filler.
- Pull down the RH side of the upper filler while carefully sliding it out of the track towards the RH side of the vehicle.
  
  Fig 1: Removing Upper Rail Filler
  Courtesy of FORD MOTOR CO.
Remove the lower rail filler.
- Pull up the RH side of the lower filler while carefully sliding it out of the track towards the RH side of the vehicle.
  
  Fig 2: Removing Lower Rail Filler
  Courtesy of FORD MOTOR CO.
Push the sliding glass upward and tilt the bottom inward to disengage the sliding glass from the track. Remove the sliding glass panel.
To install, reverse the removal procedure.