DTC Charts

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: This module utilizes a 5-character DTC followed by a 2-character failure-type code. The failure-type code provides information about specific fault conditions such as opens, or shorts to ground. Continuous memory DTCs have an additional 2-character DTC status code suffix to assist in determining DTC history.

APIM DTC CHART

DTC	Description	Action
C1001:01	Vision System Camera: General Electrical Failure	GO to PINPOINT TEST H .
All other DTCs	-	REFER to the Diagnostic Trouble Code (DTC) Charts in appropriate Information and Entertainment Systems article for the procedure.

BCM DTC CHART

DTC	Description	Action
B115E:01	Camera Module: General Electrical Failure	Sets in continuous memory in the BCM when the rear video camera status received via the LIN circuit indicates corrupted data within the rear video camera. CLEAR the DTCs and operate the rear video camera system. If DTC B115E:01 is retrieved again, INSTALL a new rear video camera. REFER to VIDEO CAMERA .
B115E:08	Camera Module: Bus Signal/Message Failure	GO to PINPOINT TEST H .
B115E:49	Camera Module: Internal Electronic Failure	Sets in continuous memory in the BCM when an electrical failure is detected from the rear video camera. CLEAR the DTCs and operate the rear video camera system. If DTC B115E:49 is retrieved again, INSTALL a new rear video camera. REFER to VIDEO CAMERA .
B115E:55	Camera Module: Not Configured	Sets in continuous memory in the BCM when the rear video camera is not configured. PERFORM the REAR VIDEO CAMERA configuration using the scan tool.
All other DTCs	-	REFER to the Diagnostic Trouble Code (DTC) Charts in MULTIFUNCTION ELECTRONIC MODULES .