LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Limited, 3.5 8, AWD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 3.5L-Ti-VCT >> Removal And Installation >> Flexplate >> Installation

Removal And Installation: Flexplate: Installation

  1. NOTE: One of the 8 flexplate holes are offset so the flexplate can only be installed in one position.

    Install the flexplate and the 8 bolts.

    • Tighten in the sequence shown in illustration to 80 Nm (59 lb-ft).
    Fig 1: Identifying Flexplate Mounting Bolts Tightening Sequence
    G08029517Courtesy of FORD MOTOR CO.
  2. Install the transaxle. REFER to the apprpriate Transmission service information article.
scientia non olet · About LEMON Manuals