LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Limited, 3.5 8, AWD >> Repair and Diagnosis >> Drivelines & Axles >> Differentials & Drive Axles >> Rear Drive Axle/Differential >> Removal And Installation >> Stub Shaft Seal >> Removal

Stub Shaft Seal: Removal

  1. NOTE: The RDU does not have stub shaft pilot bearings. It has stub shaft seals only.

    Remove the halfshaft assembly. REFER to HALFSHAFT .

  2. Using the Torque Converter Fluid Seal Remover 307-309  (T94P-77001-BH) and Slide Hammer 100-001  (T50T-100-A), remove and discard the stub shaft seal.
    Fig 1: Removing Stub Shaft Seal Using Torque Converter Fluid Seal Remover And Slide Hammer
    G06065011Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals