LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Limited, 3.5 8, AWD >> Repair and Diagnosis >> Drivelines & Axles >> Differentials & Drive Axles >> Rear Drive Axle/Differential >> Removal And Installation >> Drive Pinion Seal >> Removal

Drive Pinion Seal: Removal

  1. Remove the driveshaft. REFER to DRIVESHAFT .
  2. Using the Drive Pinion Flange Holding Fixture 205-126  (T78P-4851-A), hold the pinion flange and remove the nut. Discard the nut.
    Fig 1: Holding Pinion Flange Using Drive Pinion Flange Holding Fixture
    G06065005Courtesy of FORD MOTOR CO.
  3. Index mark the location of the pinion to the pinion flange.
    Fig 2: Identifying Index-Mark Of Pinion
    G06065000Courtesy of FORD MOTOR CO.
  4. Using the 2 Jaw Puller 205-D072  (D97L-4221-A), remove the pinion flange.
    Fig 3: Removing Pinion Flange Using Jaw Puller
    G06065001Courtesy of FORD MOTOR CO.
  5. Using the Torque Converter Fluid Seal Remover 307-309  (T94P-77001-BH) and Slide Hammer 100-001  (T50T-100-A), remove and discard the pinion seal.
    Fig 4: Removing Drive Pinion Seal Using Torque Converter Fluid Seal Remover And Slide Hammer
    G06065002Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals