LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Limited, 3.5 8, AWD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Front Disc Brake System >> Removal And Installation >> Front Brake Flexible Hose >> Removal

Front Brake Flexible Hose: Removal

  1. WARNING: Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that has been previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of serious personal injury.
    WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product MSDS, if available. Failure to follow these instructions may result in serious personal injury.
    NOTE: Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or plastic surface, immediately wash the surface with water.

    With the vehicle in NEUTRAL, position it on a hoist. REFER to JACKING AND LIFTING for Lifting Points.

  2. NOTE: Make sure to protect the brake pads from contamination from the brake fluid during the brake flexible hose installation and the brake caliper bleeding.

    Remove the brake caliper flow bolt and discard the 2 copper washers.

  3. Disconnect the brake tube fitting from the brake flexible hose.
  4. Remove the hose bracket bolt and the brake flexible hose.
scientia non olet · About LEMON Manuals