Normal Operation and Fault Conditions

When the desired memory position is selected using the memory SET switch, the DSM communicates the desired pedal position in a message on the MS-CAN  to the BCM. The BCM acts as a gateway module, relaying the message to the SCCM over the HS-CAN  . The SCCM then sends current to the adjustable pedal motor to move the pedals to the required position.

When the vehicle is unlocked using the RKE feature, a message is sent from the TPM module along a hard wired circuit to the RFA module. The RFA module then sends the message on the MS-CAN  to the BCM. The BCM transmits the message on the HS-CAN  to the SCCM. The SCCM sends current to the adjustable pedal motor to move the pedals to the position programmed to the key.