Pinpoint Test

1. Using a scan tool, perform SCCM self-test.

Were DTCs B1368:11 or B1368:12 retrieved? 

• Yes: GO to 2  .
• No: If no DTCs  were retrieved, CONFIGURE the SCCM using as-built data. TEST the system for normal operation. If any other SCCM DTCs  were retrieved, REFER to DTC CHART: STEERING COLUMN CONTROL MODULE (SCCM) .

1. Ignition OFF.
2. Disconnect Adjustable Pedal Motor.
3. Disconnect SCCM C2414C.
4. Ignition ON.
5. Measure:

   SCCM			Ground
   C2414C			Ground
   Pin	Circuit	Measurement / Action	Pin	Circuit
   3	RPP06 (GN)		-	Ground
   6	LPP08 (BU)			Ground

Is any voltage present? 

• Yes: REPAIR the affected circuit(s). CLEAR the DTCs  .
• No: GO to 3  .

1. Ignition OFF.
2. Measure:

   SCCM			Ground
   C2414C			Ground
   Pin	Circuit	Measurement / Action	Pin	Circuit
   3	RPP06 (GN)		-	Ground
   6	LPP08 (BU)		-	Ground

Are the resistances greater than 10, 000 ohms? 

• Yes: GO to 4  .
• No: REPAIR the affected circuit(s). CLEAR the DTCs  .

1. Measure:

   Adjustable Pedal Motor			SCCM
   C2003			C2414C
   Pin	Circuit	Measurement / Action	Pin	Circuit
   3	RPP06 (GN)		3	RPP06 (GN)
   4	LPP08 (BU)		6	LPP08 (BU)

Are the resistances less than 3 ohms? 

• Yes: GO to 4  .
• No: REPAIR the affected circuit(s). CLEAR the DTCs  .

1. Measure:

   SCCM			SCCM
   C2414C			Ground
   Pin	Circuit	Measurement / Action	Pin	Circuit
   3	RPP06 (GN)		6	LPP08 (BU)

Is the resistance greater than 10, 000 ohms? 

• Yes: INSTALL a new adjustable pedal motor and bracket assembly, REFER to ACCELERATOR PEDAL removal. CLEAR the DTCs  . REPEAT the self-test. If DTC B1368:11 or B1368:12 return, INSTALL a new SCCM, REFER to STEERING COLUMN CONTROL MODULE (SCCM) .
• No: REPAIR the circuit. CLEAR the DTCs  .