Roof Opening Panel Glass - Rear Fixed: Installation

NOTE: The roof opening panel motor(s) must be initialized when repairs are carried out on any part of the roof opening panel system, including whenever:

the roof opening sliding glass or power shade motor has been removed from the roof opening panel system.
the roof opening panel glass has been removed from the roof opening panel system.
the roof opening panel assembly has been removed from the vehicle.
a new roof opening sliding glass or power shade motor has been installed.
a new roof opening panel glass has been installed.
a new roof opening panel assembly has been installed.

REFER to Roof Opening Panel Motor Initialization - Sliding Glass Panel and REFER to Roof Opening Panel Motor Initialization - Shade .

Install the rear fix glass panel on the roof opening panel frame assembly and install the 8 rear fixed glass panel screws.
- Tighten to 5 Nm (44 lb-in).
Install the roof opening panel frame assembly. REFER to Roof Opening Panel Frame .
Check for correct alignment of the rear fixed glass panel. REFER to Roof Opening Panel Alignment - Rear .
Initialize the sliding glass panel motor and the power shade motor. REFER to Roof Opening Panel Motor Initialization - Sliding Glass Panel and REFER to Roof Opening Panel Motor Initialization - Shade .