Seat Latch - Power: Installation

Install the power seat latch in the following sequence.
1. Connect the 2 electrical connectors.
2. Install the 2 screws.
- Tighten to 48 Nm (35 lb-ft).
Secure the cushion cover retainers.
Install the latch cover, secure the tab and install the screw.
Install the load floor panel and secure the retainers.
Install the 2 load floor panel screws at the back of the cushion.
Attach the wire harness retainers and connect the electrical connectors to the load floor and to the vehicle.
Secure the 2 load floor supports.