LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Limited, 3.5 8, AWD >> Repair and Diagnosis >> Body & Frame >> Seats >> Seat System - Seats-Seating - 3RD Row >> Removal And Installation >> Seat Cushion Cover - Manual >> Removal

Seat Cushion Cover - Manual: Removal

NOTE: For component identification and locations, REFER to Seat - Exploded View .
  1. Remove the 2 screw and pull the cushion handle out of the pocket.
  2. Separate the pivot release cable and casing and remove the pivot release handle.
  3. Remove the 2 screws on each side at the bottom of the load floor panel.
  4. Pull out to release the retainers and remove the load floor panel.
    • Use a suitable tool to disengage the load floor from the seat.
  5. Remove the screw, release the tab and remove the floor latch cover.
  6. Release the cushion trim cover retainers from the cushion frame.
    Fig 1: Locating Cushion Trim Cover Retainers
    G06063561Courtesy of FORD MOTOR CO.
  7. Detach and remove the cushion cover.
scientia non olet · About LEMON Manuals