Power-Fold Seat Module (PFSM): Removal

NOTE: For component identification and locations, REFER to Seat - Exploded View .

NOTE: If power seat is inoperative, REFER to Manual Override of Inoperative Power Seat - 3rd Row .

Fig 1: Identifying LH Seat Load Floor Position

Courtesy of FORD MOTOR CO.

NOTE: Do not lift the load floor flapper panel too far or damage to the wire harness retainers will occur.

Fig 2: Locating Load Floor Supports

Courtesy of FORD MOTOR CO.

Separate the LH load floor support from the load floor panel.
- Push the load floor support rearward and slightly lift the load floor to disengage.
Slightly raise the LH load floor flapper panel, pull up and detach the wire harness retainer attached to the load floor support studs.

Fig 3: Locating Wire Harness Retainer Attached To Load Floor Support Studs
Courtesy of FORD MOTOR CO.
Carefully lift the LH load floor flapper panel, disconnect the electrical connectors, detach the retainers and remove the PFSM.

Fig 4: Locating Power-Fold Seat Module
Courtesy of FORD MOTOR CO.