LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Limited, 3.5 8, AWD >> Repair and Diagnosis >> Body & Frame >> Seats >> Seat System - Seats-Seating - 2ND Row >> Removal And Installation >> Seat >> Removal

Removal And Installation: Seat: Removal

  1. WARNING: Turn the ignition OFF and wait one minute to deplete the backup power supply. Ignition must remain OFF until repair is complete. Failure to follow this instruction may result in serious personal injury or death in the event of an accidental deployment.

    If installing a new component for a SRS fault, continue to step 2. Otherwise, if equipped with deployable belts, turn the ignition off, wait at least one minute and continue to step 3.

  2. NOTE: The air bag warning indicator illuminates when the correct RCM fuse is removed and the ignition is on.

    Depower the SRS: REFER to SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEPOWERING AND REPOWERING - WITH INTELLIGENT ACCESS (IA) , or REFER to SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEPOWERING AND REPOWERING - WITHOUT INTELLIGENT ACCESS (IA) .

  3. NOTE: Returning the seat from the E-Z entry position to the load floor position will latch the inboard latch foot.
    The inboard latch foot must latch before the seat backrest will return to the upright position.
    Returning the seat backrest to the upright position will latch the outboard latch foot.

    Using the recliner handle, fold the affected seat up to the E-Z entry position.

  4. If equipped, disconnect the seat electrical connector(s).
  5. Remove the 2 seat-to-floor bolts and 2 seat-to-floor nuts for the affected seat.
  6. Remove the seat.
scientia non olet · About LEMON Manuals