Removal And Installation: Seat: Installation

For the RH 40 percent seat, position the seat in the vehicle and install the retainers.
1. Install the seat-to-floor rear inboard nut.
  - Tighten to 48 Nm (35 lb-ft).
2. Install the seat-to-floor rear outboard nut.
  - Tighten to 48 Nm (35 lb-ft).
3. Install the seat-to-floor front outboard bolt.
  - Tighten to 48 Nm (35 lb-ft).
4. Install the seat-to-floor front inboard bolt.
  - Tighten to 48 Nm (35 lb-ft).
  Fig 1: Identifying Seat-To-Floor Rear Inboard/Outboard Nuts
  Courtesy of FORD MOTOR CO.
For the 60 percent seat or LH 40 percent seat, position the seat in the vehicle and install the retainers.
1. Install the seat-to-floor rear inboard nut.
  - Tighten to 48 Nm (35 lb-ft).
2. Install the seat-to-floor rear outboard nut.
  - Tighten to 48 Nm (35 lb-ft).
3. Install the seat-to-floor front outboard bolt.
  - Tighten to 48 Nm (35 lb-ft).
4. Install the seat-to-floor front inboard bolt.
  - Tighten to 48 Nm (35 lb-ft).
  Fig 2: Identifying Seat-To-Floor Rear Inboard/Outboard Nuts
  Courtesy of FORD MOTOR CO.
Connect the electrical connector(s).
If the SRS was depowered, repower the SRS. REFER to SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEPOWERING AND REPOWERING - WITH INTELLIGENT ACCESS (IA) , or REFER to SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEPOWERING AND REPOWERING - WITHOUT INTELLIGENT ACCESS (IA) .