Seat Backrest Thermo-Electric Device (TED): Installation

Install the backrest TED.
1. Position the TED through the power lumbar cable.
2. Attach the TED to the backrest foam pad wire.
3. Engage the TED upper retainers to the backrest frame wire.
4. Connect the electrical connector and attach the pin-type retainer.
Position the backrest cover downward, attach the hook-and-loop strips and engage the J-clip at the rear to the backrest frame wire.
Position the backrest cover downward, attach the hook-and-loop strips and install the 3 second row hog rings.
Position the backrest cover downward, attach the hook-and-loop strips and install the 3 first row hog rings.
Position the backrest cover downward and attach the hook-and-loop strips.
Route the wire harnesses through the backrest cover holes and engage the lower J-clips.
On each side of the seat backrest, attach the hook-and-loop strips.
Install the seat backrest. REFER to Seat - Exploded View, Front .