Dual Climate Controlled Seat Module (DCSM): Removal
NOTE:
For component identification and locations, REFER to Seat - Exploded View, Front .
-
NOTE: This step is necessary only if the DCSM is being replaced.
PMI is required when installing a new DCSM. Refer to the scan tool instructions to carry out PMI. REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
- Position the front passenger seat all the way back and up to access the DCSM.
- Remove the DCSM in the following sequence.
- Remove the screws.
- Release the locking wedges on the 2 DCSM electrical connectors.
- Disconnect the electrical connectors.
- Remove the DCSM.