LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Limited, 3.5 8, AWD >> Repair and Diagnosis >> Body & Frame >> Seats >> Seat System - Seats-Seating - 1ST Row >> Disassembly And Assembly >> Seat Backrest >> Assembly

Seat Backrest: Assembly

  1. Position the backrest frame assembly into the backrest foam pad.
  2. Install the 2 pin-type retainers.
  3. If equipped, install the power lumbar retaining clips to backrest frame and connect the power lumbar motor.
    Fig 1: Locating Power Lumbar Retaining Clips
    G06255705Courtesy of FORD MOTOR CO.
  4. If equipped, install the manual lumbar.
    1. Engage the manual lumbar retainers.
    2. Install the manual lumbar control cable retainer.
  5. If equipped, install the backrest TED.
    1. Position the TED through the power lumbar cable.
    2. Attach the TED to the backrest foam pad wire.
    3. Engage the TED upper retainers to the backrest frame wire.
    4. Connect the electrical connector and attach the pin-type retainer.
  6. If equipped, connect the backrest heater mat electrical connector and attach the pin-type retainer.
    Fig 2: Locating Backrest Heater Mat Electrical Connector
    G06063440Courtesy of FORD MOTOR CO.
  7. Install the seat backrest cover. REFER to Seat Backrest Cover .
scientia non olet · About LEMON Manuals