LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Limited, 3.5 8, AWD >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Body Panel System - Front End Body Panels >> General Procedures >> Hood Alignment >> General Procedure

General Procedure

  1. Loosen the LH and RH rear hinge-to-hood bolts to the point that the hood will have slight movement.
  2. Loosen the LH and RH front hinge-to-hood bolts to the point that the hood will have slight movement.
  3. Adjust the hood to specification. REFER to COMPONENT DESCRIPTION .
  4. Carefully open the hood and tighten the LH and RH front and rear hinge-to-hood bolts.
    • Tighten to 12 Nm (106 lb-in).
  5. NOTE: The hood adjusting bumpers are located in the hood panel.

    Adjust the hood bumpers so the hood fits flush to the fenders.

scientia non olet · About LEMON Manuals