Pinpoint Test

NOTE: The panic feature only operates when the key is in the OFF or LOCK position

VERIFY THE DOOR LOCK OPERATION
1. Press the lock and unlock button on the driver door lock control switch while observing the door lock operation.
Do the door locks operate correctly?
- Yes: GO to 2 .
- No: CHECK the symptom(s) and REFER to DTC AND SYMPTOM CHART(S) .
VERIFY THE HORN OPERATION
1. Using a scan tool, view the BCM PIDs .
2. Select the BCM PID (HORN) and active command the horn on.
Does the horn sound when commanded on?
- Yes: GO to 3 .
- No: REFER to DIAGNOSTIC ROUTINE A : The Horn Is Inoperative.
VERIFY THE HAZARD LAMP OPERATION
1. Place the hazard switch in the ON position.
Do the hazard lamps operate correctly?
- Yes: For a concern with a power liftgate, GO to 4 .
  For a concern with the factory equipped remote start, GO to 5.
  
  For vehicles with a manual liftgate and without remote start, REPLACE the inoperative IKT and PROGRAM the IKT individually or PROGRAM all the IKTs :
  
  REFER to ERASE ALL KEYS AND PROGRAM TWO KEYS ,
  
  REFER to KEY PROGRAMMING USING DIAGNOSTIC EQUIPMENT , or
  
  REFER to KEY PROGRAMMING USING TWO PROGRAMMED KEYS .
  
  If all the IKTs are to be programmed, INFORM the customer that any IKTs not present need to be programmed.
- No: REFER to DIAGNOSTIC ROUTINE R : One Turn Signal Lamp Is Inoperative Or Always On.
VERIFY THE LIFTGATE RELEASE OPERATION
1. Press the liftgate release button on the liftgate.
Does the liftgate open?
- Yes: REPLACE the inoperative IKT and PROGRAM the IKT individually or PROGRAM all the IKTs :
  REFER to ERASE ALL KEYS AND PROGRAM TWO KEYS ,
  
  REFER to KEY PROGRAMMING USING DIAGNOSTIC EQUIPMENT , or
  
  REFER to KEY PROGRAMMING USING TWO PROGRAMMED KEYS .
  
  If all the IKTs are to be programmed, INFORM the customer that any IKTs not present need to be programmed.
- No: REFER to Diagnostic Routine F: The Liftgate Latch Release Is Inoperative .
VERIFY THE REMOTE START BUTTON
1. Using a scan tool, view the BCM PIDs .
2. Select the BCM PID (LST_RKE_xMTR) while pressing the remote start button on an IKT.
Does the PID indicate the remote start button is being pressed?
- Yes: REFER to DIAGNOSTIC ROUTINE F : The Remote Start Is Inoperative.
- No: REPLACE the inoperative IKT and PROGRAM the new IKT individually or PROGRAM all the IKTs :
  REFER to ERASE ALL KEYS AND PROGRAM TWO KEYS ,
  
  REFER to KEY PROGRAMMING USING DIAGNOSTIC EQUIPMENT , or
  
  REFER to KEY PROGRAMMING USING TWO PROGRAMMED KEYS .
  
  If all the IKTs are to be programmed, INFORM the customer that any IKTs not present need to be programmed.