Pinpoint Test

VERIFY THE HIGH BEAM HEADLAMP OPERATION
1. Ignition ON.
2. Place the headlamp switch in the headlamps on position.
3. Place the multifunction switch in the high beam position while observing the headlamps.
Do the high beam headlamps illuminate?
- Yes: INSTALL a new multifunction switch. REFER to STEERING COLUMN MULTIFUNCTION SWITCH . TEST the system for normal operation.
  If the concern still exists, INSTALL a new SCCM. REFER to STEERING COLUMN CONTROL MODULE (SCCM) .
- No: REFER to Diagnostic Routine C: One Or Both High Beams Are Inoperative .