LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Limited, 3.5 8, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Warning System - Collision Avoidance >> Diagnostic Routine(S) >> Diagnostic Routine F >> Pinpoint Test

Pinpoint Test

NOTE: DTC U3003:1C may be stored in the module memory due to past battery charging or vehicle jump starting events.
  1. CHECK FOR DTC U3003:17, U3003:1C, B1317, B1676 OR P0563 SET IN OTHER MODULES
    1. Ignition ON.
    2. Using a scan tool, perform self-test.
    3. Retrieve the continuous memory DTCs  from all modules.

    Is DTC U3003:17, U3003:1C, B1317, B1676 or P0563 (PCM) set in more than one module? 

    1. Yes: REFER to DIAGNOSTIC ROUTINE A : System Voltage High to diagnose an overcharging condition.
    2. No: GO to 2  .
  2. CHECK THE BATTERY VOLTAGE
    1. Turn off all the interior/exterior lights and accessories.
    2. Start and run the engine at approximately 2, 000 RPM for 3 minutes while monitoring the battery voltage.

    Does the battery voltage rise to 15.5 volts or higher? 

    1. Yes: REFER to DIAGNOSTIC ROUTINE A : System Voltage High to diagnose an overcharging condition.
    2. No: GO to 3  .
  3. RECHECK FOR DTC U3003:1C
    1. Turn the engine off.
    2. Ignition ON.
    3. Using a scan tool, clear the HUD module CMDTCs  .
    4. Perform the HUD module self-test.

    Is DTC U3003:1C present? 

    1. Yes: INSTALL a new HUD module. REFER to Head Up Display (HUD) Module .
    2. No: The system is operating normally at this time. The DTC may have been set previously during battery charging or while jump starting the vehicle.
scientia non olet · About LEMON Manuals