Pinpoint Test

1. Ignition ON.
2. Verify there is an observable symptom present.

Is an observable symptom present? 

1. Yes: GO to 2  .
2. No: The system is operating normally at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.

1. Ignition ON.
2. Using a scan tool, perform a network test.

Does the BCM pass the network test? 

1. Yes: GO to 3  .
2. No: REFER to DIAGNOSTIC ROUTINE I : The Body Control Module (BCM) Does Not Respond To The Scan Tool.

1. Using a scan tool, perform the BCM self-test.

Is DTC U3003:16 or DTC U3003:17 recorded? 

1. Yes:

   For DTC U3003:16, REFER to DIAGNOSTIC ROUTINE H .

   For DTC U3003:17, REFER to DIAGNOSTIC ROUTINE I .

2. No: GO to 4  .

1. Using a scan tool, perform the HUD module self-test.

Is DTC U3003:16 or DTC U3003:1C recorded? 

1. Yes:

   For DTC U3003:16, REFER to Diagnostic Routine E .

   For DTC U3003:1C, REFER to Diagnostic Routine F .

2. No: GO to 5  .

1. NOTE: If new modules were installed prior to the DTC being set, the module configuration can be incorrectly set during the PMI or the PMI may not have been carried out.

   Using a scan tool, clear the DTCs  .

2. Repeat the HUD module self-test.

Is DTC U0140:00 still present? 

1. Yes: GO to 6  .
2. No: The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.

1. Clear all DTCs  .
2. Ignition OFF.
3. Ignition ON.
4. Wait 10 seconds.
5. Using a scan tool, perform self-test.
6. Retrieve the continuous memory DTCs  from all modules.

Is DTC U0140:00 set in other modules? 

1. Yes: INSTALL a new BCM:

   REFER to BODY CONTROL MODULE (BCM) - WITH INTELLIGENT ACCESS (IA) .

   REFER to BODY CONTROL MODULE (BCM) - WITHOUT INTELLIGENT ACCESS (IA) .

2. No: INSTALL a new HUD module. REFER to Head Up Display (HUD) Module .