Cruise Control Deactivation Event Parameter Identification (PIDs)
NOTE:
When recording deactivation event PIDs
, turn the cruise control OFF immediately after the deactivation event occurs to prevent recording additional deactivation events which do not apply to the fault present.
NOTE:
Cruise control deactivation PIDs
are not available on the 2.0L GTDI engine.
The PCM has PIDs available, through the powertrain DataLogger, that indicate the event that caused the last cruise control deactivation. When the cruise control is turned ON, all current deactivation (or non-activation) conditions are recorded. When the cruise control is turned OFF, event recording stops. The recorded events are stored until the ignition is turned OFF.
The PCM has 24 cruise control deactivation event PIDs , identified as CRUISEOFF_00 through 24. The event PIDs should be read when deactivation or non-activation exists.