Seat Cushion Cover - 40 Percent: Removal

NOTE: For parts identification and location, REFER to Seat - Exploded View .

Open the cushion cover.
1. Release the clip and separate the strut.
2. Separate the J-clips.
3. Separate the hook-and-loop strips.
Fig 1: Identifying Strut, J-Clips And Hook-And-Loop Strips
Courtesy of FORD MOTOR CO.
From under the seat, pull the 4 cushion cover retainers (1 shown in illustration) out from between the cushion frame and riser.

Fig 2: Locating Cushion Cover Retainers
Courtesy of FORD MOTOR CO.
Detach the clips and remove the cushion cover from the cushion foam pad.
- At installation, make sure the lower anchor and tether for children wires at the rear of the cushion frame are positioned through the cushion cover and accessible for use after installation.