Oil Pressure Sender: Service and Repair

Engine Oil Pressure (EOP) Switch

Material(s)






Exploded View










Removal

1. If equipped, remove the engine oil cooler. REFER to Oil Cooler .

2. Disconnect the EOP (Engine Oil Pressure) switch electrical connector.





3. Remove the EOP (Engine Oil Pressure) switch.





Installation

1. NOTE: Apply Thread Sealant with PTFE to the EOP (Engine Oil Pressure) switch threads prior to installation.
Install the EOP (Engine Oil Pressure) switch.
- Tighten to 14 Nm (124 lb-in) plus an additional 180 degrees.





2. Connect the EOP (Engine Oil Pressure) switch electrical connector.





3. If equipped, install the engine oil cooler. REFER to Oil Cooler .