Symptom Chart: Tire Pressure Monitoring System
Diagnostics in this information assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to
ENGINE CONTROLS - DIAGNOSTIC METHODS (EXCEPT DIESEL & HYBRID)
for information regarding Ford-specific diagnostic practices.
SYMPTOM CHART
| Condition |
Possible Sources |
Actions |
- A module does not respond to the scan tool
|
- Fuse
- Wiring, terminals or connectors
- Communication network concern
- TPM module
|
|
- The TPMS warning indicator is never or always on
|
- Communication network concern
- IPC
|
- REFER to
DIAGNOSTIC ROUTINE Q
: The Tire Pressure Monitoring System (TPMS) Warning Indicator Is Never or Always On.
|
- TPMS warning indicator is on continuously and the message center displays LOW TIRE PRESSURE
|
- Spare tire currently in use sensor(s)
- TPMS sensor(s)
- Tire pressure not set to specifications listed on the VC label
- TPMS sensor
|
- REFER to Diagnostic Routine G : Tire Pressure Monitoring System Warning Indicator is on Continuously and the message center displays Low Tire Pressure.
|
- TPMS warning indicator is on continuously and DTCs
are present
|
- Not all TPMS sensors are installed
- TPMS sensor(s) not trained
- TPMS sensor(s)
- Intermittent TPMS operation due to RFI
- TPM module wiring
- TPM module
- BCM wiring
- BCM
|
|
- The BCM will not enter TPMS sensor training mode
|
- Stoplamp switch concern
- Ignition switch concern
- VSS concern
- BCM
|
|
- One or more TPMS sensors do not train and DTCs are not
present
|
|
- REFER to Diagnostic Routine I : One or More Tire Pressure Monitoring System Sensors Do Not Train and No DTCs are Present.
|
- One or more TPMS sensors do not train and DTCs are
present
|
- TPMS sensor(s)
- Vehicle communication issue
- Intermittent TPMS operation due to RFI
- TPM module wiring
- TPM module
- BCM wiring
- BCM
|
|