Safety Belt Shoulder Height Adjuster: Installation

Install the safety belt shoulder height adjuster in the following sequence.
1. Engage the safety belt shoulder height adjuster T-tab to the B-pillar sheet metal.
2. Rotate the top of the safety belt shoulder height adjuster up 90°.
3. Install the safety belt shoulder height adjuster bolt.
  - Tighten to 40 Nm (30 lb-ft).
NOTE: Before installation, make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.

Position the D-ring and install the bolt.
- Tighten to 40 Nm (30 lb-ft).
Install the B-pillar trim panels. REFER to B-PILLAR TRIM PANEL .