Safety Belt Buckle - 2nd Row, 40 Percent Seat, with Inflatable Safety Belts: Installation
- Position the safety belt buckle on the inflator tube and install the bolt.
- Tighten to 40 Nm (30 lb-ft).
- Connect the safety belt buckle switch electrical connector.
- Reposition the cushion foam pad, cushion cover and engage the front and inboard retainers.
- Position the seat track inboard inner and outer covers and install the 5 screws.
- Prove out the SRS : Turn the ignition from ON to OFF. Wait 10 seconds, then turn the ignition back to ON and monitor the air bag warning indicator with the air bag modules installed. The air bag warning indicator illuminates continuously for approximately 6 seconds and then turns off. If a SRS fault is present, the air bag warning indicator:
- fails to light.
- remains lit continuously.
- flashes.
The flashing might not occur until approximately 30 seconds after the ignition has been turned from OFF to ON. This is the time required for the RCM to complete the testing of the SRS. If the air bag warning indicator is inoperative and a SRS fault exists, a chime sounds in a pattern of 5 sets of 5 beeps. If this occurs, diagnose and repair the air bag warning indicator and any SRS faults.
- Check the active restraint system for correct operation. REFER to Functional Test - Safety Belt Buckle and Tongue .