DTC Charts: Notes

WARNING: This page is about a different variant/trim than selected.

Diagnostics in this service information assume a certain skill level and knowledge of Ford-specific diagnostic practices. Refer to DIAGNOSTIC METHODS for information about these practices.

When the electrical connector or solenoid body is disconnected, inspect the connector for terminal condition, corrosion and contamination. Also inspect the connector seal for damage. Clean, repair or install new components as required.

Power is routed through the transmission solenoid power control relay (inside the TCM ) to all transmission solenoids. If the power circuit to the transmission solenoids or the transmission solenoid power control relay fails open, then all solenoids are failed electrically OFF. Check for open, short to ground or the transmission connector disconnected. The transmission solenoid power control relay disables power to the transmission solenoids when certain transmission DTCs are set.