Torque Specifications
WARNING: This page is about a different variant/trim than selected.
TORQUE SPECIFICATIONS
| Description | Part Number | Torque |
|---|---|---|
| A/C compressor bolt | W714077 | 25 Nm (18 lb-ft) |
| A/C compressor nut | W520413 | 25 Nm (18 lb-ft) |
| A/C compressor stud | W712610 | 9 Nm (80 lb-in) |
| A/C compressor tube bracket bolt | W503302 | 25 Nm (18 lb-ft) |
| Accessory drive belt tensioner bolts | Part of 6A228 | 25 Nm (18 lb-ft) |
| Balancer shaft assembly bolts | 6A313 | REFER to Balance Shaft Backlash |
| Battery terminal nut | N805320 | 9 Nm (80 lb-in) |
| Bellhousing-to-engine bolts | W714288 , W500124 | 48 Nm (35 lb-ft) |
| Bellhousing-to-engine stud bolt | W715721 | 48 Nm (35 lb-ft) |
| Bellhousing-to-oil pan bolts | W500235 | 48 Nm (35 lb-ft) |
| Brake vacuum pump adapter | 6K269 | 63 Nm (46 lb-ft) |
| Brake vacuum pump bolts | W500015 | 10 Nm (89 lb-in) |
| Camshaft bearing cap bolts | W703383 | REFER to Camshafts |
| Camshaft phaser and sprocket bolts | 6279 | 72 Nm (53 lb-ft) |
| CAC inlet tube clamp | Part of 6C646 | 5 Nm (44 lb-in) |
| CAC intermediate tube mounting bracket fasteners | W520201 , W702928 | 8 Nm (71 lb-in) |
| CAC outlet tube clamp | Part of 6K863 | 5 Nm (44 lb-in) |
| Connecting rod cap bolts | 6214 | REFER to Assembly |
| Coolant outlet bolts | W500015 | 10 Nm (89 lb-in) |
| Coolant pump bolts | W500015 | 25 Nm (18 lb-ft) |
| Coolant pump pulley bolts | W500221 | 20 Nm (177 lb-in) |
| CKP sensor | W701219 | 7 Nm (62 lb-in) |
| Crankshaft pulley bolt | 6K340 | REFER to Crankshaft Pulley |
| Crankshaft rear seal with retainer plate bolts | W500212 | REFER to Crankshaft Rear Seal with Retainer Plate |
| Crankcase vent oil separator bolts | W500214 | 10 Nm (89 lb-in) |
| CHT sensor | 6G004 | 11 Nm (97 lb-in) |
| Cylinder head bolts | 6065 | REFER to Cylinder Head |
| Degas bottle bolts | W706681 | 9 Nm (80 lb-in) |
| Engine appearance cover mounting stud | 6A957 | 5 Nm (44 lb-in) |
| Engine coil-on-plug bolts | W500301 | 8 Nm (71 lb-in) |
| Engine coil-on-plug stud bolts | W715638 | 8 Nm (71 lb-in) |
| Engine eye lift bolts | W500033 | 47 Nm (35 lb-ft) |
| Engine front cover bolts | W500215 , W500300 , W500328 , W711261 | REFER to Engine Front Cover |
| Engine mount bolts | W712507 | 90 Nm (66 lb-ft) |
| Engine mount nuts | W520214 | 125 Nm (92 lb-ft) |
| EOP | 9278 | 15 Nm (133 lb-in) |
| Engine piston oil cooler bolts | W500211 | 10 Nm (89 lb-in) |
| Engine plug bolt | W700115 | 20 Nm (177 lb-in) |
| Flexplate bolts | W706161 | REFER to Flexplate |
| Fuel injection pump bolts | W500414 | REFER to Assembly |
| Fuel injection pump bracket bolts | W702362 | 17 Nm (150 lb-in) |
| Fuel injection pump housing | W702700 | 15 Nm (133 lb-in) plus an additional 60 degrees |
| Fuel jumper tube bolt | W708662 | 8 Nm (71 lb-in) |
| Fuel rail bolts | W500313 | 8 Nm (71 lb-in) plus an additional 26 degrees |
| Generator bolts | W503302 | 25 Nm (18 lb-ft) |
| Generator terminal nut | W711953 | 17 Nm (150 lb-in) |
| Ground wire bolt (on cylinder head) | W715723 | 20 Nm (177 lb-in) |
| Ground wire stud bolt (on LH inner fender) | W710897 | 10 Nm (89 lb-in) |
| Ground wire nut (on starter stud bolt) | W805024 | 18 Nm (159 lb-in) |
| Ground strap bolt (on RH inner fender) | W705661 | 11 Nm (97 lb-in) |
| Ground strap nut (on engine front cover stud bolt) | W707137 | 9 Nm (80 lb-in) |
| High pressure fuel tube bracket bolts | W500015 | 10 Nm (89 lb-in) |
| High pressure fuel tube flare nuts | part of 9H589 | REFER to Assembly |
| Idler pulley bracket bolts | W500113 | 25 Nm (18 lb-ft) |
| Idler pulley bracket nuts | W520413 | 25 Nm (18 lb-ft) |
| Intake manifold bolts | W500313 | REFER to Intake Manifold |
| KS bolts | W500310 | REFER to Assembly |
| Main bearing beam bolts | 6345 | REFER to Assembly |
| Oil cooler | W706487 | REFER to Oil Cooler |
| Oil filter | 6714 | 8 Nm (71 lb-in) plus an additional 180 degrees |
| Oil filter adapter bolts | W500225 | 25 Nm (18 lb-ft) |
| Oil pan drain plug | 6730 | 27 Nm (20 lb-ft) |
| Oil pan bolts | W500224 , W706284 | REFER to Oil Pan |
| Oil pan-to-bellhousing bolts | W500122 | 48 Nm (35 lb-ft) |
| Oil pump drive chain tensioner shoulder bolt | W703651 | 10 Nm (89 lb-in) |
| Oil pump bolts | W712022 | REFER to Oil Pump |
| Oil pump screen and pickup tube bolts | W706282 | 10 Nm (89 lb-in) |
| Oil pump sprocket bolt | W704397 | 25 Nm (18 lb-ft) |
| RH halfshaft bracket bolts | W500113 | 25 Nm (18 lb-ft) |
| RH halfshaft bracket nuts | W701731 | 25 Nm (18 lb-ft) |
| Starter motor stud bolts | W715721 | 35 Nm (26 lb-ft) |
| Starter wire terminal nut (large) | W706414 | 12 Nm (106 lb-in) |
| Starter wire terminal nut (small) | W705790 | 5 Nm (44 lb-in) |
| Thermostat housing bolts | W500015 | 10 Nm (89 lb-in) |
| Timing chain guide bolts | W703643 | 10 Nm (89 lb-in) |
| Timing chain tensioner bolts | 6K282 | 10 Nm (89 lb-in) |
| Torque converter nuts | W715618 | 40 Nm (30 lb-ft) |
| Transaxle mount bolt | W500761 | 150 Nm (111 lb-ft) |
| Transaxle control selector cable bracket bolts | W714824 | 25 Nm (18 lb-ft) |
| Turbocharger heat shield bolts | W714133 | 10 Nm (89 lb-in) |
| Turbocharger coolant tube bolts | W715500 | 28 Nm (21 lb-ft) |
| Turbocharger inlet tube bolt | W700005 | 5 Nm (44 lb-in) |
| Turbocharger inlet tube clamp | - | 5 Nm (44 lb-in) |
| Turbocharger inlet tube stud bolt | W714640 | 5 Nm (44 lb-in) |
| Turbocharger oil drain tube bolts | W500212 | 10 Nm (89 lb-in) |
| Turbocharger oil supply tube bolts | 6C712 | 25 Nm (18 lb-ft) |
| Turbocharger outlet tube clamp | - | 5 Nm (44 lb-in) |
| Turbocharger-to-cylinder head studs | W704474 | 17 Nm (150 lb-in) |
| Turbocharger-to-cylinder head nuts | W713095 | REFER to Assembly |
| TCM bracket bolt | W506432 | 11 Nm (97 lb-in) |
| TCM bracket nut | W714682 | 63 Nm (46 lb-ft) |
| Valve cover retainers | Part of 6K271 | REFER to Valve Cover |
| VCT solenoid bolts | W500211 | 10 Nm (89 lb-in) |