Removal And Installation: Flexplate: Installation

WARNING: This page is about a different variant/trim than selected.

NOTE: Special bolts are used for installation. Do not use standard bolts.

Install the flexplate, the 6 new bolts and the Flywheel Holding Tool.
- - Tighten in the sequence shown in illustration in 3 stages:
  - Stage 1: Tighten to 50 Nm (37 lb-ft).
  - Stage 2: Tighten to 80 Nm (59 lb-ft).
  - Stage 3: Tighten to 120 Nm (89 lb-ft).
Fig 1: Identifying Bolts Tightening Sequence Of Flex Plate
Courtesy of FORD MOTOR CO.
Install the transaxle. REFER to the appropriate Transmission.
After completing the repairs, use the scan tool to perform the Misfire Monitor Neutral Profile Correction procedure, following the on-screen instructions.