Camshaft Phaser and Sprocket: Installation

WARNING: This page is about a different variant/trim than selected.

NOTE: Do not reuse the camshaft phaser and sprocket washers. New washers must be installed.

Install 2 new washers.

Fig 1: Locating Camshaft Phaser And Sprocket Washers
Courtesy of FORD MOTOR CO.
NOTE: Do not tighten the camshaft phaser and sprocket bolts at this time. The bolts will be tightened during the timing drive component installation procedure.

Install the intake and exhaust camshaft phaser and sprockets.
- Install the 2 bolts finger-tight.
Fig 2: Locating Intake And Exhaust Camshaft Phaser And Sprockets Bolts
Courtesy of FORD MOTOR CO.
Install the timing drive components. REFER to Timing Drive Components .